USING OUR
HOW TO USE
1
Before first use, remove plastic tab and ring by pulling the tab all the way around the cap. Once detached, remove the cap.
2
Place balloon on nozzle. Hold in place.
3
Gently tilt the nozzle to release helium. Inflate until balloon is an egg shape.
4
Pull off balloon and pinch. Tie the balloon and add ribbon.
5
After use, replace cap and store in a cool, dry place.
1
To open, rotate green valve 4 full turns, counterclockwise.
2
Place balloon on black nozzle; hold in place.
3
Gently press down near end of nozzle to release helium.
4
Tie off the balloon and add ribbon.
5
After use, close green valve tightly. Store in a cool, dry place.
1
Place the air inflator on a clean, flat surface. Plug into a grounded 110V-120V electric outlet.
2
Determine which tip to use. Then attach tip to base (if applicable).
3
Determine which mode to use. Mode switch can be found at the top of the inflator.
4
Push to Inflate Mode: Hold balloon tightly over chosen tip. Press single balloon button, then push down to inflate. Release to stop.
5
Continuous Run Mode: Attach the air valve to the nozzle, and hold tightly. Continuous Run mode will begin inflating once power switch is turned on. Turn off to stop.
1
Plug into a grounded 110V-120V electric outlet.
2
Determine which tip to use based on what you wish to deflate.
3
Attach tip to bottom of unit. Insert tip into the air valve of the inflatable.
4
Flip power switch to Continuous Run power mode to deflate.
Do not exceed 2 minutes of continuous use. Allow motor to rest for 15 minutes if using for more than 2 minutes.
Watch How To Video
1
When it comes to DIY, our Jumbo Helium Tank is a party-sized way to set your celebration afloat.
2
When it comes to DIY, our Jumbo Helium Tank is a party-sized way to set your celebration afloat.
3
When it comes to DIY, our Jumbo Helium Tank is a party-sized way to set your celebration afloat.
4
When it comes to DIY, our Jumbo Helium Tank is a party-sized way to set your celebration afloat.
5
When it comes to DIY, our Jumbo Helium Tank is a party-sized way to set your celebration afloat.
6
When it comes to DIY, our Jumbo Helium Tank is a party-sized way to set your celebration afloat.
1
Gather your supplies. Wear protective gloves and goggles.
2
Fully open green valve by turning counterclockwise.
3
Push down on nozzle until tank is empty (hissing sound will stop).
4
Unscrew white valve nut.
5
Remove nozzle and discard.
6
Use hammer and flat head screwdriver to lift, peel back and discard the small disk.
7
Circle the open hole and write “empty” on the tank.
8
Recycle or dispose. Check locally for options.
AVERAGE FLOAT TIME
Altitude, high temperature and humidity will affect balloon performance.
Maximize Your Float
Our Helium Tanks are Proudly
With Global Components
